From Profile refrigerators to front-load washers, our technicians know GE's motors, sensors and control boards. We diagnose the fault, quote it upfront, and carry the parts London homes need most.
GE appliances we repair
GE Refrigerator Repair
French door, side-by-side, Profile
GE Washer Repair
Top-load, front-load, UltraFresh
GE Dryer Repair
Electric, gas & sensor dry
GE Dishwasher Repair
Built-in, Dry Boost
GE Oven Repair
Wall & built-in, true convection
GE Stove Repair
Gas, electric & induction
Our team repairs GE appliances to the manufacturer's own specifications, not guesswork.
Most GE repairs are wrapped up the same day, so you're not left waiting around.
Every GE repair is backed by our 90-day warranty on both parts and labour.
We fit genuine GE parts so your appliance keeps running the way it should.
Same-day and next-day appointments across London, ON. Factory-trained on Samsung, with common parts on the van and a 90-day workmanship warranty.
Service area
A look at the problem, the fix, and what it cost around London.
$180The washer filled and drained but wouldn't spin the load dry. We replaced a worn motor coupling and the lid switch, and it spins clothes out properly again.
$170Dishes stayed damp even on Dry Boost. We replaced the vent and heating element and confirmed a full dry at the end of the cycle.
$215One cooktop element stayed cold. We replaced the element and a burnt terminal block, and all burners heat evenly now.
Prices shown are the total charged for that specific job and are for reference only. Your quote is confirmed on site before any work begins.
Call and book a diagnostic for your GE appliance today at (226) 242-0249.
The GE-specific faults our technicians run into most often.
A worn coupling, lid switch or suspension is usually behind it. We replace the parts so the drum spins clothes out again.
A failing fan, damper or sealed-system part throws the temperature off. We diagnose it and restore steady cooling.
Clothes come out damp because the heating circuit has failed. We test the element and controls and get it hot again.
A tired heating element or vent leaves dishes wet on Dry Boost. We replace the part for a proper dry.
An "F" code often points to the oven sensor or control. We read the code, replace the part and confirm it holds temperature.
A dead element or terminal block leaves a burner cold. We replace it so every burner heats evenly.
Fault guide
GE ranges and ovens show "F" codes, while GE washers and dishwashers usually flash lights instead of a code. Here's what those signals point to. Knowing the symptom before you call helps us arrive with the right part.
Oven too hot
Over-temperature; often a faulty sensor or relay.
Sensor open
Oven temperature sensor circuit is open.
Sensor shorted
Oven temperature sensor is shorted out.
Stuck button
A key on the control panel is shorted or stuck.
Door lock fault
Door latch or lock motor not working.
Not taking water
Inlet valve, float switch or supply issue.
Water left in tub
Drain pump, filter or hose blocked.
Water on the floor
Door seal, hose or pump gasket fault.
Cycle won't begin
Door latch, control lock or control board.
Poor drying
Heating element or vent needs replacing.
Load stays wet
Motor coupling, lid switch or drive fault.
Shakes and stops
Worn suspension or an uneven load.
Water left in drum
Drain pump or hose blocked.
Little or no water
Inlet valve or water-level sensor fault.
Lid won't lock
Lid lock assembly or switch fault.
GE fault codes and light patterns vary by series and year. When in doubt, call us with your model number and we'll walk you through it.
Getting your GE appliance fixed is as easy as it should be.
Reach out by phone or the booking form. We listen and set up your appointment.
Your technician shows up on time with a van stocked with common GE parts.
We pinpoint the exact fault and give you an upfront price before any work starts.
We complete the repair, test the appliance, and tidy up before we leave.
Book now
Tell us the model and what it's doing. We'll confirm a same-day or next-day visit and arrive ready to repair it.
(226) 242-0249Fill out the form and we'll get back to you shortly.
Your message has been sent successfully. We'll get back to you shortly.
Your request has been sent. We'll get back to you shortly.
